32tons 32t Heavy Forklift FD320

32tons 32t Heavy Forklift FD320

HNF-320 Rated load: 32,000 kgs Load center:1250 mm Operating weight: 41,000 kgs Wheel base: 4,800 mm 32tons 32t heavy forklift FD320 Email: claire@socmachinery.com
Chat Now

Product Details

Email: claire@somachinery.com 


32tons 32t heavy forklift FD320 brand SOCMA vs Kalmar, Hyster, Konecranes, Sany, TCM, CVS 


The forklift, as the most widely used machine, has the advantage of fast moving speed, and often needs to travel on all kinds of ground. Whether the brake is in good condition, whether the steering wheel is old or new, or even the glass is clean, the angle of the reversing mirror is directly related to safe driving.

 

 

This is often met on the earth and stone field. In this case, take care to control the speed of the throttle and not to shake it. Individuals often install half shovel soil in the bucket to relieve the body's bouncing. The short wheelbase car, when the car is old, is articulated loosely and larger than the middle / long shaft bump on this ground is more likely to cause an accident caused by the rupture of the steering oil pipe.

 

 

 

32tons 32t heavy forklift FD320 brand SOCMA vs Kalmar, Hyster, Konecranes, Sany, TCM, CVS 


The above two figures are an analogical display of simple pavement or partial pavement. Driving at night at such a road is initially an easy impulse for people to run. If the lights are not uniform and the glass is too dirty, the driver will easily be injured in the cab because of the bouncing of the car body.

 

 

 

 

 

The above shows the bright and dark Alternation under the good road surface. In this case, we should turn on the headlights in advance to slow down the eyes and adapt to the change of light.

 

 

The above picture shows common construction roadways, which can also be compared to simple roads in mountainous areas. In this case, it is best not to brake a lot more dangerous to go up and down. Don't do it if you have to put a bucket on the ground and hang upside down at idling to use the torque converter as a retarder to use the emergency refueling door forklift back. Another extreme situation is that when the steering force is greater than the steering force when the slope is too large, downhill gear can be used less or no braking to ensure the normal steering work.

 

32tons 32t heavy forklift FD320 brand SOCMA vs Kalmar, Hyster, Konecranes, Sany, TCM, CVS 


This is a common village road in the countryside on both sides of the thick grass, I do not know whether there are ditches or sharp stones below, sometimes on one side is a hillside side side is a deep ditch. In this case, the bucket is laid flat about 20 centimeters off the ground and slowly passes through if there is a seedling with a steeply inclined body, immediately lowering the bucket flat against the ground and reversing. In particular, it is pointed out that sometimes the front wheel side has sunk to the rear axle swing to the limit position and then flip the bucket will overturn the car.

 

 

 

The above picture is analogous to the narrow section of the factory. Watch carefully when you whistle slowly, because you can not know in advance whether there are people or vehicles on the side. Especially in the factory area, it is more ineffective.

 

 

Personally, I think this is the most difficult aspect. We should pay attention to the falling stones on the road side. Rain or snow is the easiest time to roll stones. If you take part in rush projects, you must pay attention to safety. Personal experience is to roughly finish the shovel loading process according to experience after the material is being loaded. Do not turn your head on the side of the car.

In the city road, please respect the rules and regulations because the forklift starts more slowly than the car.


Email: claire@socmachinery.com 


ItemItem  details  Unit 
HNF-320
FeaturesRated LoadQ(t)32
Load centerc(mm)1250
Wheelbasey(mm)4800
WeightWeightkg40600
ChassisTyre Specs.:Front
14.00-24-32PR
Tyre Specs.:Rear
14.00-24-32PR
Tyres Qty,front/rear(X-drive wheels)
4\2
Wheel tread:Frontb10(mm)2420
Wheel tread:Rearb11(mm)2390
DimensionMast/carriage tilt angle(front/rear)Degree(°)6\12
Mast height(fork lowering)h1(mm)3950
Mast lifting heighth3(mm)3500
Max.lifting heighth4(mm)5700
Height to head guard(height to cab)h6(mm)3800
Overall height(with forks)l1(mm)9590
Fork front vertical surface to the rear end of the vehiclel2(mm)7150
Overall widthb1/b2(mm)3200
Fork dimensions/e(mm)2440X320X110
Fork carriage widthb3(mm)3100
Mast min ground clearance                 (with load)m1(mm)350
Wheelbase center min ground clearance(with load)m2(mm)410
Min.Turning radiusWa(mm)7260
Travel speed(with load/without load)km/h24/28
PerformanceMax.lifting speed(with load/without load)mm/s260/280
Max.Lowering speed(with load/without load)mm/s250/180
TractionN22000
Gradeablity(with load/without load)20/21
Driving brake
Hydraulic clamp disc

Engine  brand/modelOptional one               Weichai engine
Engine
 WO10G240E341
9.726L 178KW 2200rpm
Optional two                 Dongfeng Cummins

  QSC8.3-C260
8.3L 194KW 2200rpm
Cylinder No.6
OthersTransmission gears(Front/rear)
2\1
Attachments working pressure bar180
Attachments using oil amountl/min80


Inquiry